173mm
4
Blind Nut (5mm)
Linkage Stopper
Washer (2mm)
Washer (2mm)
Nut (2mm)
Set screw (3x4mm)
Washer (2mm)
Set screw (3x4mm)
1
1
1
1
Assemble the servos and switch.
1
Linkage Stopper
4
12
Washer(5mm)
Spring Washer (5mm)
1
4
Screw (5mm)
Plastic tube (2x650mm)
Washer
4
4
Blind Nut (5mm)
Fuel tank (550cc)
1
(Not included)
(Not included)
(Not included)
(Not included)
The front view when the 50cc engine install completion.
The side view when the 50cc engine install completion.
Drill four holes at the diameters as show
for engine mount.
6.2mm
Blind Nut
Assemble the engine.
Washer (5mm)
Screw (5mm)
50
51
52
53
54
10
Accessory list for the coming installation steps.
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
3mm
Glue the elevator to the stabilizer by CA and epoxy.
B'
A
A'
B
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
A = A '
B = B '
2
2
Clevis
Copper joiner
2
2
Screw (2x10mm)
Nut (2mm )
2
Washer(2x5mm)
Steel wire
Copper joiner
Lock Nut (2mm )
Screw (2x10mm)
Ball joint
Washer(2x5mm)
Install the servo.
Assemble the elevator sever to appropriate position
in the fuselage.
Connect the elevator and the servo via the steel wire.
Elevator servo steel wire
4
Plastical tube(3x30mm)
2
Steel wire (0.5x3000mm)
2
2
2
Clevis
Washer(3x15mm)
Lock Nut (3mm )
1
Screw (3x80mm)
4
Copper joiner
3
Pin hinge(4.7x70mm)
4
Clevis
4
4
Screw (2x10mm)
Nut (2mm )
4
Washer(2x5mm)
Assembly of the stabilizer.
34
35
36
37
33
7
Accessory list for the coming installation steps.
