4mm
4
Wood dowel (4x30mm)
Wood dowel (4x30mm)
1mm
Elevator
Tailing
edge
Make sure they are in
the right position while
installing.
Keep some space about 1mm width between
elevator and tailing edge.
Make sure hinges are
mounted in the same line.
3mm
6
Pin hinge(24x24mm)
Apply instant type CA glue to elevator and pin hinge.
Set the U-style wire through the enlarged hole as below.
2
1
Steel wire (0.5x3000mm)
U-style wire 150x25mm
U-style wire 150x25mm
Stab joiner (12x260mm)
1
Stab joiner (12x260mm)
1x20mm
Drill holes to appropriate position in the stabilizer and
epoxy it to the fuselage as below.
The sketch map of the steel wires in the fuselage.
Drill two holes at the stabilizer root base on rib template
and epoxy the wood dowel in them.
27
28
29
30
31
32
6
switch servo
Elevator servo
Throttle servo
Rudder servo
Add a rubber ring to the
clevis for insuring safety
Fuel supply line
Fuel spray line
Air pressure line
Assembly of the fuel tank.
Mount the fuel tank to the fuselage.
Fuel tank (550cc) 1
1
Former for fuselage
1
Cowling former
TP Screw(3x20mm)
Washer (3x6mm)
4
4
The servos installation finished sketch map.
Assemble the receiver and the battery to appropriate
in the fuselage.
Install the servo of swith.
Assemble the throttle servo in the fuselage.
1
Canopy
2
PVC
2
PVC
1
PVC
1
PVC
1
PVC
57
56
59
60
11
58
Accessory list for the coming installation steps.
