Install the servo as the illustration below
TP Screw (2.3x12mm)
4mm
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
Flap
1mm
Make sure they are in
the right position while
installing.
Trailing
edge
1.5mm
6
Pin hinge(24x24mm)
173
o
2mm
Keep some space
between the flaps.
Metal wire (1.7x210mm)
2
Metal wire (1.7x210mm)
10
Pin hinge(24x24mm)
2
Metal wire (1.7x210mm)
Rod (2.5x300mm)
Clevis
Clevis
Lock Nut (4mm )
Screw (3x10mm)
Nut (3mm )
Screw (4x40mm)
Washer
8
2
2
2
2
2
2
2
Clevis
Clevis
Rod (2.5x300mm)
TP Screw (2.3x12mm)
Wooden Block(20x20x8mm)
Servo tray(68.5x56.5x2mm)
Screw (4x35mm)
2
Washer
Lock Nut (4mm )
2
Washer(4x14mm)
2
Collar (3mm)
Washer(4x14mm)
Secure the servo.Install the nylon control horn
and connect the linkage.
Epoxy the flaps to the wings as illustration.
Keep some space about 1mm width between
trailing edge and flap.
Connect the two flaps with metal wire,keep some space
between them and epoxy the pinned hinges to the flaps
as below.
7
6
8
9
10
2
Accessory list for the coming installation steps.
Add a rubber ring to the
clevis for insuring safety
2
Fiber deconations
Deconation
Cut off the surplus part from the cowling,exhausts and
canopy carefully.
2
Pvc part
B'
A
A'
B
Make sure to glue securely.
If not properly glued, a failure in flight may occur.
Temporarily fasten down the main wing and
check its correct position.
Securely glue together.If coming off during flights,
you'll lose control of your airplane which leads
to accidents!
A = A '
B = B '
The sketch map should be when the stabilizer
assembly completion.
Clevis
1
Rod (2x300mm)
1
1
Retainer
1
Ring
1
1
Air tank
Switch
Install the servo of swith.
The servos installation finished sketch map.
16
Ply(15x15x2mm)
16
TP Screw (2.3x8mm)
1
Canopy
2
Pvc part
1
2
Throttle servo
Rudder servo
Elevator servo
switch servo
Epoxy the exhaust the the cowling as figure.
Ply (2mm)
56
58
59
11
57
55
Accessory list for the coming installation steps.
