5
SECTION 2: ASSEMBLING YOUR SNOW THROWER
Unpacking
•
Remove screws from the top sides and ends of the
shipping crate.
•
Set panel aside to avoid tire punctures or personal
injury.
•
Remove and discard plastic bag that covers unit.
•
Remove any loose parts included with unit (i.e.,
Operator’s Manual, etc.).
•
Roll unit out of crate.
Loose Parts
The augers are secured to the auger shaft with two
shear pins and cotter pins. If you hit a foreign object or
ice jam, the snow thrower is designed so that the pins
may shear. Two replacement shear pins and cotter pins
are provided for your convenience. Store in a safe
place until needed. See Figure 1.
Figure 1
IMPORTANT:
NEVER replace the auger shear pins with
standard hex pins. Any damage to the auger gearbox or
other components from using standard pins will not be
covered by your snow thrower’s warranty.
Items Required For Assembly
1.
Pair of pliers
2.
Engine oil
3.
Fresh gasoline
Before Assembly
•
Disconnect spark plug wire and ground it against
the engine to prevent unintended starting.
NOTE: All references in this manual to the left or right
side of the snow thrower is from the operating position
only. Exceptions, if any, will be specified.
Assembling Handle
For shipping purposes, the upper handle is secured
loosely to the lower handle with four wing nuts.
•
Remove the
lower
plastic wing nut, cupped washer
and carriage bolt from each side of the lower
handle. See Figure 2.
•
Raise the upper handle assembly until it locks over
the lower handle.
•
Look at the lower rear of the snow thrower frame to
be sure all the cables are aligned with the cable
roller guides. Make sure the spring (found at the
end of each cable) is attached to its actuator
bracket.
•
Secure the upper handle and lower handle with the
two plastic wing nuts, cupped washers and carriage
bolts previously removed. Attach these hardware
on the lower hole in the handles. See Figure 2.
•
Tighten the two wing nuts already in place on the
upper holes and secure the handles firmly. Slide
the shift rod connector down over the end of the
lower shift rod. Tap the connector until it
locks
over
the lower shift rod. See Figure 2.
NOTE: If the connector is not properly assembled, the
shift rod will pivot and you will not be able to change
speeds or direction of movement.
Figure 2
Attaching Chute Directional Control
Model 1028
•
Remove the hairpin clip from the upper chute rod
and slide the upper chute rod through the upper
chute rod bracket and into the lower chute rod. A
pair of pliers may help in this job.
•
Align the two holes on both chute rods and insert
the hairpin clip removed earlier, through these
holes. See Figure 2.
Model 1130
•
Adjust the eyebolt on the chute directional control
so the rod does not come into contact with the
engine by moving the hex nut against the handle (if
necessary). Retighten the wing nut to secure the
directional control in this position.
Shear Pins
Cotter
Pins
Wing
Nut
Upper
Chute
Rod
Lower Chute Rod
Carriage Bolt
Hairpin Clip
Cupped
Washer
Carriage
Bolt
Содержание Storm Tracker 1028
Страница 30: ...30 NOTES ...
