3
SECTION 1: IMPORTANT SAFE OPERATION PRACTICES
This sym bol points out im portant safety instructions, w hich if not follow ed, could endanger the personal
safety and/or property of yourself and others. R ead and follow all instructions in this m anual before
attem pting to operate this m achine. Failure to com ply w ith these instructions m ay result in personal
injury. W hen you see this sym bol— heed its w arning
.
WARNING:
Engine Exhaust, som e of its constituents, and certain vehicle com ponents contain
or em it chem icals know n to the State of C alifornia to cause cancer, birth defects or other
reproductive harm
.
DANGER:
This m achine w as built to be operated according to the rules for safe operation in this
m anual. As w ith any type of pow er equipm ent, carelessness or error on the part of the operator can
result in serious injury. This m achine is capable of am putating hands and feet and throw ing objects.
Failure to observe the follow ing safety instructions could result in serious injury or death
.
TRAINING
1.
Read, understand, and follow all instructions on the
machine and in the manual(s) before attempting to
assemble and operate. Keep this manual in a safe place
for future and regular reference and for ordering
replacement parts.
2.
Be familiar with all controls and their proper operation.
Know how to stop the machine and disengage them
quickly.
3.
Never allow children under 14 years old to operate this
machine. Children 14 years old and over should read and
understand the operation instructions and safety rules in
this manual and should be trained and supervised by a
parent.
4.
Never allow adults to operate this machine without
proper instruction.
5.
Thrown objects can cause serious personal injury. Plan
your snow-throwing pattern to avoid discharge of material
toward roads, bystanders and the like.
6.
Keep bystanders, helpers, pets and children at least 75
feet from the machine while it is in operation. Stop
machine if anyone enters the area.
7.
Exercise caution to avoid slipping or falling, especially
when operating in reverse.
PREPARATION
1.
Thoroughly inspect the area where the equipment is to
be used. Remove all doormats, newspapers, sleds,
boards, wires and other foreign objects, which could be
tripped over or thrown by the auger/impeller.
2.
Always wear safety glasses or eye shields during
operation and while performing an adjustment or repair to
protect your eyes. Thrown objects which ricochet can
cause serious injury to the eyes.
3.
Do not operate without wearing adequate winter outer
garments. Do not wear jewelry, long scarves or other
loose clothing, which could become entangled in moving
parts. Wear footwear which will improve footing on
slippery surfaces.
4.
Use a grounded three-wire extension cord and
receptacle for all units with electric start engines.
5.
Adjust collector housing height to clear gravel or crushed
rock surfaces.
6.
Disengage all controls before starting the engine.
7.
Never attempt to make any adjustments while engine is
running, except where specifically recommended in the
operator’s manual.
8.
Let engine and machine adjust to outdoor temperature
before starting to clear snow.
9.
To avoid personal injury or property damage use extreme
care in handling gasoline. Gasoline is extremely
flammable and the vapors are explosive. Serious
personal injury can occur when gasoline is spilled on
yourself or your clothes, which can ignite. Wash your skin
and change clothes immediately.
a.
Use only an approved gasoline container.
b.
Extinguish all cigarettes, cigars, pipes and other
sources of ignition.
c.
Never fuel machine indoors.
d.
Never remove gas cap or add fuel while the
engine is hot or running.
e.
Allow engine to cool at least two minutes before
refueling.
f.
Never over fill fuel tank. Fill tank to no more than
½ inch below bottom of filler neck to provide space
for fuel expansion.
g.
Replace gasoline cap and tighten securely.
h.
If gasoline is spilled, wipe it off the engine and
equipment. Move machine to another area. Wait 5
minutes before starting the engine.
i.
Never store the machine or fuel container inside
where there is an open flame, spark or pilot light
(e.g. furnace, water heater, space heater, clothes
dryer etc.).
j.
Allow machine to cool at least 5 minutes before
storing.
OPERATION
1.
Do not put hands or feet near rotating parts, in the auger/
impeller housing or chute assembly. Contact with the
rotating parts can amputate hands and feet.
2.
The auger/impeller control is a safety device. Never
bypass its operation. Doing so makes the machine
unsafe and may cause personal injury.
3.
The controls must operate easily in both directions and
automatically return to the disengaged position when
released.
4.
Never operate with a missing or damaged chute
assembly. Keep all safety devices in place and working.
Содержание Storm Tracker 1028
Страница 30: ...30 NOTES ...
