Only required for low-contamination filter
changes:
Fig. 13: Attaching the maintenance sack
10.
Put the maintenance sack (Fig. 13/1) over
the service board (Fig. 13/2) and fasten it in
the first groove with the clamping ring
(Fig. 13/3).
11.
Roll up the maintenance sack and place it in
front of the particulate filter element.
Note: When rolling up the maintenance
sack, make sure that the ends of the sack
do not protrude over the service board.
Fig. 14: Closing the casing
12.
Place the cover on the filter casing, and
tighten the star knob screws (Fig. 14/1)
hand-tight.
IMPORTANT
The casing cover can only be
mounted when the clamping frame is ten-
sioned.
13.
EXPLOSION HAZARD!
KSFS-...-Ex: Mount the earthing cable
from the filter chamber cover (Fig. 2/2).
Maintenance
KSFS
∙
KSFS-...-Ex Ducted particulate filters
12
