Inserting the insert mask
Fig. 2: Inserting the insert mask
Attaching the mask
Before unpacking the masks, wash your hands and
disinfect them if necessary.
If required, remove any protective glasses or visual
aids.
1.
Remove the mask from the packaging and
insert the insert filter, Fig. 2.
2.
Hold the mask at the neck loop (Fig. 1/4)
using both hands and draw it up and over
your head until it reaches the nape of your
neck.
3.
Tie the open head straps (Fig. 1/2) behind
your head (above the ears).
4.
Adjust the nose piece to the shape of your
nose.
Checking the seal
1.
Place both hands on the mask without
pressing the mask to the face.
2.
To check for leakage, breathe out strongly.
If air escapes, check that the mask is fitted
correctly:
Nose: readjust the nose piece to fit the
nose.
Rim of mask: adjust the head straps or
tie a knot.
3.
Check again to make sure the mask has
formed a seal.
If the mask has not formed a correct seal, do not
enter the risk zone
Þ
Inform your superior!
Removing the mask
Before removing the masks, wash your hands and
disinfect them if necessary.
If required, remove any protective glasses or visual
aids.
1.
Loosen the head straps (Fig. 1/2) and bring
them forward.
2.
Extend the neck loop (Fig. 1/3) by pulling the
filter cloth (Fig. 1/1).
3.
Draw the neck loop over the head towards
the front.
4.
Remove the insert filter from the mask and
dispose of it immediately in a bin; do not
leave it down on any surface.
5.
Clean the mask according to the instruc-
tions.
6.
Then wash your hands and disinfect them if
necessary.
Inserting the insert mask
X filter mask with insert filter in accordance with testing principles for Corona SARS-Cov-2 pandemic breathing masks
(CPA)
3
