10
EN
hand-held vacuum cleaner VC 10-20 V
Switching the device off
1. Slide the on/off switch (
1
) backward to
0
.
1
ð
The device is switched off.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable of
the charger out of the mains socket.
•
Remove the battery from the device (see Start-up chapter).
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Transport and storage
chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the operating manual.
Using insertion tools or accessories other than those
specified in the operating manual may cause a risk of
injury.
Designation
Article number
Multiflex 20V 2.0 Ah spare battery 6.200.000.303
Multiflex 20V 4.0 Ah spare battery 6.200.000.320
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
Troubleshooting tasks which require the housing to be opened
must only be carried out by an authorized specialist electrical
company or by Trotec.
Light smoke or odour is emitted during the first use:
•
This is not a fault. These phenomena disappear after a
brief runtime.
The device becomes hot:
•
Keep the venting slots clear to prevent the motor from
overheating.
Info
Wait for at least 10 minutes before switching the
device back on.
The device does not start:
•
The battery power might be too low. Recharge the battery.
•
Check whether the battery is correctly connected to the
device.
Slide the battery onto the device in a way that the battery
terminals engage. The battery must lock in place in the
device.
•
Check the battery terminals for dirt. Remove any dirt.
The battery does not charge:
•
Check whether the battery is correctly connected to the
quick charger.
Slide the battery into the quick charger in a way that the
battery terminals engage in the quick charger. The battery
must lock in place in the quick charger.
•
Check the power connection.
•
Check the power cable and mains plug for damages.
•
Check the fuse (home).
•
Check the quick charger for damages. Should the quick
charger be damaged, stop using it. Contact the Trotec
customer service.
•
Check the battery terminals for dirt. Remove any dirt.
•
The battery might be defective and have to be replaced.
Only use batteries of the same type.
Info
Wait for at least 10 minutes before switching the
device back on.
Note
Wait for at least 3 minutes after maintenance and
repair work. Only then switch the device back on.
