Operating Manual – Electric hot air generator
B -
1
EN
Safety instructions
m
Please read the instructions carefully and
thoroughly before assembling, using or
cleaning the appliance. The use of the heater
can cause severe injury due to burns, fire or
electrical discharge.
This appliance is transportable and made especially
for closed quarters such as warehouses, shops and
homes, as well as for humid and damp quarters such
as construction sites. The appliance complies with di-
rective EN 60335-2-30/1998, Keymark all.B control,
and therefore directive B.T. 73/23/EEC and 93/68EEC.
•
Keep the appliance at a minimum-security dis-
tance of 0.5 metres from combustible materials.
Never use the appliance in rooms where petrol,
solvents, paints or any other substance that gives
off combustible gases, are kept, or near curtains or
other drapery.
•
Keep the appliance out of the reach of children and
animals.
•
Only use the appliance with a power supply that
complies with the frequency and voltage require-
ments specified on the rating plate.
•
Use only three wire extension power cables with
ground wire and adequate lengths.
•
Unplug the appliance from the outlet when not in
use.
•
The appliance should never be positioned directly
under outlets.
•
Should the appliance be left temporarily in insecure
conditions, make sure that it cannot be used and
that the plug is disconnected.
•
Do not use this heating device near washbasins,
bathtubs, showers or swimming pools.
•
Before beginning any kind of maintenance or re-
pairs on the appliance make sure the plug is defi-
nitely disconnected from the outlet.
•
Do not cover the appliance; it could cause
over-heating.
Unpacking
•
Remove all the material used to pack the appliance
for transportation.
•
Remove all the objects from the box.
•
If the heater looks damaged, immediately inform
the retailer where the appliance was bought.
Functioning
m
Read the instructions in the safety infor-
mation section thoroughly. The instructions
must be followed carefully in order for the
heater to function safely.
Make sure the electric cable is not damaged in any
way. If the electric cable is damaged it must be imme-
diately replaced by the manufacturer, by the Service
Center or by specialized personnel only. Make sure
that the electrical characteristics of the outlet corre-
spond to the requirements stated in the instruction
booklet and/or on the rating plate found on the appli-
ance. Place the appliance in an upright position.
Turning on the heater
Plug the electric cable into the outlet. Rotate the knob
to the required position:
1. Fan only
2. Minimum
3. Maximum
Switching off the heater
Let the fan run for 3 minutes before turning the heater
off. Rotate the knob to the “0” position.
Regulating the thermostat
By rotating the knob that controls
the thermostat, you can regulate
the room temperature.
When the desired temperature is
reached the thermostat automati-
cally switches the resistance off but the fan continues
working.
RESET