Trotec TCH 2000 E, Руководство по эксплуатации

Страница: 6 / 18

5 EN Operating manual – designer glass convector TCH 2000 E
Transport and storage
Notice
If you store or transport the device improperly, the
device may be damaged.
Note the information regarding transport and storage of
the device.
Transport
Before transporting the device, observe the following:
• Switch off the device.
• Hold onto the mains plug while pulling the power cable out
of the mains socket.
• Do not use the power cable to drag the device.
• Allow the device to cool down sufficiently.
Storage
Before storing the device, proceed as follows:
• Allow the device to cool down sufficiently.
When the device is not being used, observe the following
storage conditions:
• dry and protected from frost and heat
• in an upright position where it is protected from dust and
direct sunlight
• with a cover to protect it from invasive dust if necessary
• Place no further devices or objects on top of the device to
prevent it from being damaged.
• Remote batteries from the remote control.
Assembly and installation
Scope of delivery
• Device
• Remote control
• Wall holder
• 2 x Screw for wall mounting
• 2 x Plastic dowel for wall mounting
• 2 x Fastening screw with steel dowel for wall mounting
• 2 x Foot
• 8 x Screw for feet assembly
• Manual
Unpacking the device
1. Open the cardboard box and take the device out.
2. Completely remove the packaging.
3. Fully unwind the power cable. Make sure that the power
cable is not damaged and that you do not damage it during
unwinding.
Feet assembly
1. Place the device on a table or on the packaging board with
the glass surface pointing down.
2. Fasten both feet (3) with four screws each.
3
3. Check the feet (3) for tight fit.