10
EN
planer PPLS 10-750 / PPLS 10-800
Mounting the rip fence
The rip fence serves as a guide for precise working at the edge
of a workpiece. Furthermore, you can use the rip fence to
reduce the width of the planing track or of the base plate resting
on the workpiece.
Proceed as follows to mount the rip fence:
1. Use the fastening screw (
3
) to fasten the rip fence (
8
) to
the left side of the device. Note that the guide rail (
20
)
must always point downwards.
3
8
20
2. Loosen the set screw (
21
) to adjust the width of the base
plate (
7
) or the position of the guide.
I.
II.
7
21
3. Tighten the set screw (
21
) after the desired position has
been set.
Info
If you are using the rip fence, apply slight lateral
pressure on the device while guiding it over the
workpiece.
Adjusting the rebating depth stop
The rebating depth stop serves to adjust the depth of the
planing track on your workpiece.
Please proceed as follows to adjust the rebating depth stop:
1. Set the desired depth using the fastening screw (
5
) at the
rebating depth stop (
9
).
5
9
Info
If you are using the rebating depth stop and the rip
fence simultaneously, you can create steps with the
desired depth (rebating depth stop) and width (rip
fence).
Adjusting the chip ejector
Info
The function described below applies exclusively to the
PPLS 10-750.
You can mount the chip ejector on the left or right-hand side of
the device as needed.
The chip ejector is already preassembled.
Warning of hand injuries
Do not insert any limbs or objects into the chip ejector.
Crushing hazard if handled without due care.
Wear protective gloves!
Warning
Toxic dusts!
The harmful / toxic dusts produced during operation
pose of risk to the health of the operator and persons
in the vicinity.
Wear eye protection and a dust mask!
