20
EN
cordless grinder PMTS 01-12V
The device becomes hot:
•
Make sure not to exert too much pressure on the device
during grinding.
•
Select a lower speed by turning the setting wheel for
speed selection (
25
) to a low level.
•
Check whether the tool is suitable for the tasks to be
carried out.
•
Keep the venting slots clear to prevent the motor from
overheating.
Info
Wait for at least 10 minutes before switching the
device back on.
The tool is loose:
•
Make sure that the clamping nut (
26
) is tightened properly
to the tool holder.
The cutting disc has difficulties with penetrating the
material to be processed or the cutting performance of the
abrasive wheel is insufficient:
•
Check whether the chosen tool is suitable for the material
to be processed.
•
Check the set speed; it must be suitable for both the tool
and the material.
•
Select a higher speed by turning the setting wheel for
speed selection (
25
) to a higher level.
•
If the cutting disc or abrasive wheel is worn, replace it with
a new one.
Note
Wait for at least 10 minutes after maintenance and
repair work. Only then switch the device back on.
The device still does not operate correctly after these
checks:
Please contact the customer service. If necessary, bring the
device to an authorised specialist electrical company or to
Trotec for repair.
Maintenance
Activities required before starting maintenance
Warning of electrical voltage
Do not touch the mains plug or the battery with wet or
damp hands.
•
Switch the device off.
•
Allow the device to cool down completely.
•
Remove the battery from the device.
Warning of electrical voltage
Maintenance tasks which require the housing to be
opened must only be carried out by authorised
specialist companies or by Trotec.
Notes on maintenance
Inside the device, there are no parts that need to be maintained
or lubricated by the user.
Cleaning
The device should be cleaned before and after each use.
Note
The device does not have to be lubricated after
cleaning.
Warning of electrical voltage
There is a risk of a short-circuit due to liquids
penetrating the housing!
Do not immerse the device and the accessories in
water. Make sure that no water or other liquids can
enter the housing.
•
Clean the device with a soft, damp and lint-free cloth.
Make sure that no moisture enters the housing. Protect
electrical components from moisture. Do not use any
aggressive cleaning agents such as cleaning sprays,
solvents, alcohol-based or abrasive cleaners to dampen
the cloth.
•
Dry the device with a soft, lint-free cloth.
•
Remove any abrasive dust and, if applicable, wood chips
from the tool holder.
•
Keep the connecting terminals on the device and charger
clean.
•
Keep the ventilation openings free from dust deposits to
prevent overheating of the motor.
