EN
19
cordless belt sander PBSS 10-20V
•
Reduce the pressure applied on the workpiece.
•
Check whether the workpiece is suitable for the tasks to
be carried out.
The surface of the workpiece is not smooth or the grinding
performance is insufficient:
•
Check whether the selected abrasive belt is suitable for the
material to be processed.
•
If the abrasive belt is worn, replace it with a new one, see
chapter Changing the abrasive belt.
•
Check the belt speed setting. It must be suitable for both
the abrasive belt and the material.
•
Select a higher speed level by turning the setting wheel for
the belt speed selection to the desired level.
The device becomes hot:
•
Check whether the selected abrasive belt is suitable for the
tasks to be carried out.
•
Make sure not to exert too much pressure on the device
during grinding.
•
Keep the venting slots clear to prevent the motor from
overheating.
•
Wait for at least 10 minutes before switching the device
back on.
The device still does not operate correctly after these
checks:
Please contact the customer service. If necessary, bring the
device to an authorised specialist electrical company or to
Trotec for repair.
Maintenance
Activities required before starting maintenance
Warning of electrical voltage
Do not touch the mains plug or the battery with wet or
damp hands.
•
Switch the device off.
•
Allow the device to cool down completely.
•
Remove the battery from the device.
Warning of electrical voltage
Maintenance tasks which require the housing to be
opened must only be carried out by authorised
specialist companies or by Trotec.
Notes on maintenance
Inside the device, there are no parts that need to be maintained
or lubricated by the user.
Safety signs on the battery and the charger
Check the safety signs attached to the battery and the charger
at regular intervals. Replace illegible safety signs!
Cleaning
The device should be cleaned before and after each use.
Note
The device does not have to be lubricated after
cleaning.
Warning of electrical voltage
There is a risk of a short-circuit due to liquids
penetrating the housing!
Do not immerse the device and the accessories in
water. Make sure that no water or other liquids can
enter the housing.
•
Clean the device with a soft, damp and lint-free cloth.
Make sure that no moisture enters the housing. Protect
electrical components from moisture. Do not use any
aggressive cleaning agents such as cleaning sprays,
solvents, alcohol-based or abrasive cleaners to dampen
the cloth.
•
Dry the device with a soft, lint-free cloth.
•
Keep the connecting terminals on the device and charger
clean.
•
Keep the ventilation openings free from dust deposits to
prevent overheating of the motor.
•
Remove dust and chips from the chip ejector. If the chip
ejector is blocked, clean it with suitable means (e.g.
compressed air).
Emptying the dust bag
The device accomplishes a high removal rate. For optimum
working conditions regularly empty and clean the dust bag.
1. Remove the dust bag (
9
) from the dust extraction
connection (
5
).
2. Open the zip fastener (
22
) at the dust bag (
9
).
3. Completely empty the dust bag (
9
).
22
4. Close the zip fastener (
22
) at the dust bag (
9
), and, if
required, remount the dust bag
9
) to the dust extraction
connection (
5
) of the device.
