12
EN
cordless belt sander PBSS 10-20V
Inserting the battery
1. Slide the battery (
6
) into the holder until it locks in place.
14
6
Removing the battery
1. Detach the battery (
6
) from the device by pressing and
holding the unlocking button (
14
, I.) and pulling the battery
off the device (II.).
I.
II.
2. If required, charge the battery (
6
) as described in the
section
Charging the battery
.
Checking the battery charging status
The battery comes with an integrated battery level indication.
The battery status is displayed as follows by the three LEDs of
the battery level indication (
13
):
LED colour
Meaning
Green – Orange – Red
maximum charge / power
Orange – Red
medium charge / power
Red
weak charge – recharge the
battery
1. Press on the battery icon (
19
) on the battery (
6
).
ð
You can read the battery status from the battery level
indication (
13
).
19
13
Changing the abrasive belt
Warning of electrical voltage
Before any work on the device, remove the mains plug
from the mains socket and the battery from the device!
Hold onto the mains plug while pulling the power cable
out of the mains socket.
Note
Observe the abrasive belt's movement direction.
Make sure to exchange the abrasive belt in due time.
Otherwise the abrasive belt might tear and cause
damage to the workpiece.
Note
The abrasive belt must not be kinked.
The abrasive belt is preassembled.
The abrasive belt can be exchanged for processing different
materials. Moreover available are different grain sizes for coarse
to fine sanding. It might be necessary to adjust the speed of
rotation / belt speed according to the new abrasive belt.
