5
EN
Operating manual – air cleaner AirgoClean 10 E
Operation
Notice
Avoid open doors and windows.
After being switched on, the device operates fully automatically.
Operating elements
1
No.
Designation
1
On/off switch
Switching the device on / selecting the fan speed
Once you have completely installed the device as described in
the Start-up chapter, you can switch it on.
1. Set the on/off switch (1) to the desired fan stage.
Stage I = low fan speed
Stage II = medium fan speed
Stage III = high fan speed
ð
The device is switched on.
Ionization
With this function, the room air is not only cleaned by means of
the HEPA filter, but additionally by means of ions. The released
ions remove pollen, dust, viruses and bacteria from the room
air.
Ionization starts automatically once you switch on the device.
Ionization cannot be switched off.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Set the on/off switch (1) to
0
.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Storage chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the operating manual.
Using insertion tools or accessories other than those
specified in the operating manual may cause a risk of
injury.
Designation
Article number
HEPA filter, filter class H11
7.160.000.510
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
The device does not start:
•
Check the power connection.
•
Check the power cable and mains plug for damages.
•
Check the on-site fusing.
•
Wait for 10 minutes before restarting the device. If the
device is not starting, have the electrics checked by a
specialist company or by Trotec.
The device is loud or vibrates:
•
Check whether the device is set up in a stable and upright
position.
The device works with reduced capacity:
•
Check the HEPA filter for dirt. If necessary, clean or replace
the HEPA filter.
•
The air outlet is obstructed. Make sure that the air outlet is
not blocked. Remove any loose objects from the air outlet.
•
The HEPA filter's plastic cover was not removed before
installation. Take the HEPA filter out of the plastic cover.
The device works with no capacity or the air quality does
not improve:
•
Check whether any windows and/or doors of the room are
open. If so, close them.
•
The HEPA filter is not installed. Install the HEPA filter.
•
Check the minimum distance to walls or other objects.
Position the device a little more in the room's centre if
required.
The device gives off an unpleasant odour:
•
Check the HEPA filter for dirt. If necessary, clean or replace
the HEPA filter.
•
Smoke, e.g. dense tobacco smoke, may produce odours
and contaminations in the air. Ventilate the room.
