EN
Operating manual – Videoscope VSC3008
6
Inserting the SD card
1. Open the rubber tab on the left side of the device.
2. Insert the SD card in the SD card slot (13).
– The printed side of the SD card should point up and the
rounded corner to the bottom right.
3. Slightly press down the SD card until it engages.
4. Close the rubber tab.
Switch-on
1. Press the On/Off button (12) for approx. 5 seconds.
– An acoustic signal will be emitted three times. The display
is switched on and the device is ready for operation.
Aligning/moving/holding the camera
1. Use the cursor (9) to move the camera (3) in the desired
direction.
2. Hold the cursor in this position and press the padlock button
(10).
– The camera head is fixed in its position.
– A padlock appears on the display.
– The cursor (9) is locked.
Caution!
Avoid pulling on the probe cable while the lock in enabled;
the camera head and the cable may get damaged!
The camera head is held in position by the lock (padlock
symbol) and can thus inadvertently become a barbed
hook.
Note:
If the position of the camera head is maintained for at least three
seconds via the cursor, the lock is automatically activated!
3. Press the padlock button (10) again to unlock the camera
head.
– The camera head moves back to a neutral position.
– The padlock symbol on the display disappears.
Note:
Always carry out this HOME function before pulling the probe
cable out of the inspected hollow space to prevent the camera
head from getting caught, and thus to avoid damage to the
Bowden cables in the probe cable!
Taking a picture
1. Press the photo button (8).
– The picture is taken and saved.
Recording a video
1. Press the video button (7).
– The videoscope switches to recording mode.
– The recording is started.
– A video camera symbol appears in the top left of the
display.
2. Press the video button (7) again.
– The recording is stopped.
13
6
12
11
7
8
10
9
