Trotec 1210002004, Руководство по эксплуатации, Страница: 11 / 18

EN Operating manual – Local air conditioner PAC 2000 E 10
Error code Display Fault Cause Remedy
H3 n. a.
Compressor overload
protection
• The inside of the device is heavily contaminated Contact Trotec
• Air inlet or air outlet is blocked
Remove any foreign objects and dirt from the
air inlet and outlet.
Observe the minimum distances specified in
the technical data
• The fan does not run or runs too slowly Contact Trotec
• Compressor malfunction: Temperature at the
housing is very high, compressor makes unusual
noises or refrigerant leaks Contact Trotec
• The system is blocked on the inside Contact Trotec
• Pump does not operate or condensate cannot be
discharged
Contact Trotec
• The rubber stopper at the condensate outlet is not
properly attached.
Check the rubber stopper for tight fit
• Refrigerant leaks Contact Trotec
E8 n. a. Overload malfunction
• The inside of the device is heavily contaminated Contact Trotec
• Air inlet or air outlet is blocked
Remove any foreign objects and dirt from the
air inlet and outlet.
Observe the minimum distances specified in
the technical data
• The fan does not run or runs too slowly Contact Trotec
• Compressor malfunction: Temperature at the
housing is very high, compressor makes unusual
noises or refrigerant leaks Contact Trotec
• The system is blocked on the inside Contact Trotec
• The temperature sensor on the mainboard cannot
determine temperature
Contact Trotec