10
EN
dehumidifier TTK 165 ECO / TTK 170 ECO / TTK 380 ECO
Mounting the transport handle
Prior to initial start-up, the transport handle must be attached to
the device. To do so, please proceed as follows:
TTK 165 ECO / TTK 170 ECO
1. Mount the transport handle (1) to both feet (4) using four
screws.
1
4
TTK 380 ECO
1. Mount the handle (1) on both sides of the device using two
hexagon screws each.
Start-up
When positioning the device, observe the minimum distance
from walls or other objects as described in the chapter
Technical annex.
A
B
C
C
D
•
Before restarting the device, check the condition of the
power cable. If there are doubts as to the sound condition,
contact the customer service.
•
Only position the device in rooms where potentially leaking
refrigerant cannot accumulate.
•
Only position the device in rooms where there is no source
of ignition (e.g. open flames, an active gas appliance or an
electric heater).
•
Only put up the device in an upright, stable position on firm
ground.
•
Do not create tripping hazards when laying the power
cable or other electric cables, especially when positioning
the device in the middle of the room. Use cable bridges.
•
Make sure that extension cables are completely unrolled.
•
When positioning the device, keep a sufficient distance to
heat sources.
•
Make sure that no curtains or other objects interfere with
the air flow.
