EN
9
air cleaner TAC 750 E
Operation
Operating elements
7
8
No.
Designation
Meaning
7
power
button
For switching the device on and off
8
air volume
control
dial
For setting the desired air volume
Switching the device on
Once you have positioned the device as described in the Start-
up chapter, you can switch it on.
1. Ensure that air inlet and outlet are not covered.
2. Turn the
air volume
control dial (8) counter-clockwise to
the lowest air volume.
3. Press the
power
button (7).
ð
The
power
button (7) lights up.
Adjusting the air volume
By use of the infinitely variable air flow regulation you can adjust
the fan speed and thus regulate the air flow rate of the device.
1. To increase the air volume, turn the
air volume
control
dial (8) clockwise.
2. To decrease the air volume, turn the
air volume
control
dial (8) counter-clockwise.
Shutdown
Warning of electrical voltage
Do not touch the mains plug with wet or damp hands.
•
Switch off the device.
•
Hold onto the mains plug while pulling the power cable out
of the mains socket.
•
Clean the device according to the Maintenance chapter.
•
Store the device according to the Transport and storage
chapter.
Available accessories
Warning
Only use accessories and additional equipment
specified in the instructions.
Using insertion tools or accessories other than those
specified in the instructions may cause a risk of injury.
Designation
Article number
G3 spray paint filter
7.160.000.416
G4 Z-line filter
7.160.000.404
F7 pleated filter cartridge
7.160.000.409
H13 high-efficiency particulate air filter
(HEPA)
7.160.000.220
Air transport hose Tronect SP-T 203
6.100.001.200
Hose/pipe adapter (Ø123)
6.100.010.010
Air transport hose Tronect TF-L 127
6.100.001.120
Errors and faults
The device has been checked for proper functioning several
times during production. If malfunctions occur nonetheless,
check the device according to the following list.
The device does not start:
•
Check the power connection.
•
Check the power cable and mains plug for damage.
•
Check the on-site fusing.
•
Wait for 10 minutes before restarting the device. If the
device is not starting, have the electrics checked by a
specialist company or by Trotec.
The device is loud or vibrates:
•
Check whether the device is set up in a stable and upright
position.
The device gets very warm, is loud or is losing
performance:
•
Check the air inlets and air filters for dirt. Remove external
dirt.
The device gives off an unpleasant odour:
•
Smoke, e.g. dense tobacco smoke, odours and
contaminations may be in the air. Ventilate the room.
The device still does not operate correctly after these
checks:
Please contact the customer service. If necessary, bring the
device to an authorised specialist electrical company or to
Trotec for repair.
