Canopy
Screw
Key
Hole
Push up canopy until the screw still in the mounting bracket
is engaged with the large end of the keyhole on canopy.
Rotate canopy slightly until the screw head is engaged
in the narrow end of the key hole.
Insert the remaining canopy screw into the other hole,
and tighten both canopy screws.
3. Installing the canopy
Note: Two screws are pre-installed on mounting bracket for
canopy installation. You will need to remove one and loosen
the other slightly.
3. CANOPY INSTALLATION
4. BLADE INSTALLATION
4. Installing the blades
Align three holes in blade with the three posts on blade arm
and secure with blade screws and washers.
Repeat for remaining blades.
Blade Screw
Flat Washer
Paper Washer
(3)
Blade Arm
Blade
Groove
Nib
Continue at step 7.
Lift light cover to
motor aligning the
opening of the
grooves to the nibs
inside the lower plate.
Rotate cover clockwise to secure
it to motor assembly.
5. Installing the Light Cover
If you are installing with the light...
5. LIGHT COVER INSTALLATION
If you are installing without the light, proceed to Step 6A on next page.
