5:REMOTE INSTALLATION
Remove battery cover.
FAN code setting:
There are 4 switches for 16 possible code combinations just in case your house has other fans installed
with the same codes. You may change your code switches by using a small screwdriver or ball point pen
to slide each code switch firmly up or down.
1
2
Note: IF ONLY ONE FAN TO BE INSTALLED IN THE HOUSE, YOU CAN SKIP THIS STEP.
3
4
LIGHT On/Off-Dimming
:
This switch is to interchange light function while using
bulbs (Dimming) or CFL bulbs (On/Off).
*
function: Slide the code to “D” position (for
bulbs)
*
function: Slide the code to “ON” position (for CFL bulbs)
Install 12V 23AE battery x 1 pc.
code setting
incandescent
incandescent
Dimming
On/Off
5A. Initial Settings (Back side of Transmitter)
1. Code setting on TRANSMITTER.
2
1 2 3 4 X
D
ON
1 2 3 4
ON
ECE
1
3
D
ON
4
12V 23AE Battery x 1 pc
Pressing the button
for 3~5 seconds till the fan
,
which means this remote control is doing the setting. Fan will operate clockwise for 2.5 minutes
and anti-clockwise for 2.5 minutes, then stop automatically. (Totally 5 minutes for SETTING.)
“SET”
operates
5B. SETTING before starting fan.
5C. TRANSMITTER BUTTON
P6
Your fan is ready for operation.
Light switch (two options)
1. On/Off (for CFL bulbs)
2. Dimming (for incandescent bulbs)
Fan ON/OFF switch:
Reversing function
The picture is showing
for CFL bulbs.
VI
I
II
III
IV
V
SET
(Lowest Speed)
(Highest Speed)
6 speeds from (Lowest Speed)
to
(Highest Speed).
I
VI
