6
4’ x 8’ Rectangular Party Lounger
Step 1 Assembly of 4’ x 8’ Party Lounger
Place (1) 4’ x 8’ Party Lounger Sectional Frame to be assembled
at
or near
the desired location for use.
Step 2 Cushion Attachment – 4’ x 8’ Party Lounger
WARNING:
Do not try to lift or move the Seat Cushion with only
one person. This component is heavy and awkward to handle, and
may result in injury to persons or damage to property if not lifted
properly.
Place Seat Cushion with Velcro Straps facing down onto your 4’ x
8’ Party Lounger Frame.
Engage Velcro Straps (12) to Frame Seating Grid Bracing, located
around the perimeter of your Square Party Lounger.
3
Step 2 Sectional Attachment – 8’ x 8’ Party Lounger
Align the second 4’ x 8’ Party Lounger Sectional Frame to be
attached to the first Sectional with the Connector Plates installed.
WARNING:
The attachment of your (2) 4’ x 8’ Party Lounger
Sectional Frames requires assembly in the center of the item. Do
not step or climb on the frame of your Party Lounger Sectionals.
Use a supporting platform, such as cardboard over the seating
grid when performing the below step. Failure to do so could result
in injury to persons or damage to property.
Align both upper and lower Connector Brackets with the assembly
holes in upper and lower side bracing of the second 4’ x 8’ Party
Lounger Sectional Frame.
Install the remaining (8) ¼-20 x 7/8” Hex Head Bolts fitted with (8)
¼” Locking Washers and (8) ¼” Flat Washers through the
Connector Brackets into the assembly holes. Be sure that the
Sectionals are properly aligned at the end of the joined items.
Fully tighten all (16) Hex Head Bolts.
DO NOT STEP OR CLIMB ON SEATING GRID WITHOUT THE
USE OF A SUPPORTING PLATFORM MATERIAL SUCH AS
CARDBOARD!
Side of Party Lounger Frame
Ends of Party
Lounger Frames
