Tronair JP30, Руководство по эксплуатации и обслуживанию, Страница: 70 / 83

EQUALIZATION:
When using multiple batteries in a series string, cells become uneven during charge and discharge
cycles. At least once a month perform two charge cycles back to back, this will give a chance for cells
that are lagging behind to catch up, and is important to overall battery performance. NOTE: This only
needs to be done when using the wet cell or AGM settings with a standard, or extended
gassing/absorption cycle. (Switch #1 ON).
SAFETY INFORMATION AC WIRING:
Before making AC connections, refer to the requirements on the charger ID label. If your charger is not
equipped with an AC plug,
for example, a 230 volt charger , have a qualified electrician install one.
To reduce the risk of fire, use this charger only on branch circuits that are protected by a circuit breaker
or fuse, and that are adequate to carry the power drawn by the charger. All wiring should be in
accordance with the National Electric Code, ANSI/NFPA 70, and all local codes and ordinances.
This battery charger must be grounded to reduce the risk of electric shock. 117 volt chargers are
equipped with a grounding type plug, 230 volt chargers are shipped without a plug. Have a qualified
electrician install a properly grounded 3 wire plug.
DO NOT USE THIS CHARGER ON A TWO POLE UNGROUNDED OUTLET OR ATTEMPT TO
BREAK OFF THE GROUND PRONG FOR USE ON A RECEPTACLE OR EXTENSION CORD
NOT HAVING A GROUND.
If an extension cord must be used, make sure it is in good condition. Use a three conductor cord no
smaller than the size being used on the charger, and keep it as short as possible. The use of an improper
extension cord could result in a risk of a fire or electric shock. Locate all cords so that they will not be
stepped on, tripped over, or otherwise subjected to damage or stress.
OTHER SAFETY INFORMATION:
Do not use charger if it shows signs of physical stress, or if DC output leads or connector feel hot when
used.
Do not disconnect the DC output clamps, or connector from the batteries when the charger is on. The
resulting arcing could cause the batteries to explode.
Do not expose charger to rain.
The charger will become hot during use, provide adequate air flow around it. Do not place charger on
cloth or vinyl seats, blankets, or around any other obstructive materials. Do not place charger against
walls, allow 12” of space on all sides.