5 Ton (4.5 Metric Ton) Single Stage Jack
Models: 02-7856-0100 (Standard)
02A7856-0100 (with Air Pump Option)
02B7856-0100 (with Air Pump Option & Spring Loaded Casters)
02C7856-0100 (with Spring Loaded Casters)
11/2004 - AA - Rev. 04
- 8 -
7.4.2 Jack
Instructions
(continued)
WARNING!
•
The ram locknuts are user operated safety devices. Failure to utilize these locknuts may
result in personal injury or death.
•
Do not place hands on top of jack near ram locknuts while lowering jack. Pinch points
exist between top of jack and threads on ram.
•
Always wear safety glasses.
To Lower Aircraft:
1. Lower all jacks simultaneously.
2. If ram locking nut(s) is tight, raise jack slightly to release nut(s).
3. Loosen pump release valve slightly to slowly lower aircraft. Raise locking
nut(s) as jack ram(s) lower.
NOTE:
When using jack during washing operations, completely cover top of jack near ram
seal.
8.0 TRAINING
Training of operating personnel is the responsibility of the employer. This jack must be used in accordance
with aircraft manufacturer’s instructions.
9.0 MAINTENANCE
9.1 GENERAL
•
All maintenance and/or repair work should be done using good workmanship practices and
proper tools.
•
The work area should be clean and free of dirt.
•
When O-rings and backup rings are removed, every effort should be made to avoid the contact of
tools with the critical surfaces of parts. Surface deformities could cause degradation of seals and
failure.
•
It is good practice to replace both O-rings and backup rings once removed. Cut and damaged O-
rings normally result in fluid leakage.
•
If cylinder bore is found to be rusty, it may be honed to a maximum diameter of 2.629 inches
(66.78 mm) and a surface finish of 16 micro inches. If pitting in the bore cannot be removed by
this process, the jack cylinder must be replaced before the jack can be returned to service.
•
At this time, flush old hydraulic fluid and dirt from overall system and replenish with new, clean
hydraulic fluid.
•
When refilling the hydraulic system the characteristics of the hydraulic fluid used in the jack and
the level of the hydraulic fluid as it is noted on the jack shall be observed.
•
Jacks shall be maintained and repaired in accordance with the manufacturers instructions. Such
maintenance and repair shall be carried out by qualified persons.
•
No modifications shall be carried out which adversely affect the compliance of the jack with draft
standard prEN 1494:1994.
Содержание 02-7856-0100
