1
rev. 041814
Model HJ1800AU
1,800 kg Aluminum-Steel Hybrid Jack
For Technical Questions, Call: 1-800-879-7316
Warning information
This is the safety alert symbol. It is used to alert you
to potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
imPortant: rEaD tHESE inStrUCtionS BEforE oPErating
BEFORE USING THIS DEVICE, READ THIS MANUAL COMPLETELY AND THOROUGHLY, UNDERSTAND ITS OPERATING
PROCEDURES, SAFETY WARNINGS AND MAINTENANCE REQUIREMENTS.
It is the responsibility of the owner to make sure all personnel read this manual prior to using the device. It is also the responsiblity of the
device owner to keep this manual intact and in a convenient location for all to see and read. Contact Arcan for a replacement label if your
jack's label is not readable.
tHE natUrE of HaZarDoUS SitUationS
The use of Portable Automotive Lifting Devices are subject to certain hazards that cannot be prevented by mechanical means, but only
by the exercise of intelligence, care, and common sense. It is essential to have personnel involved in the use and operation of the device
who are careful, competent, trained, and qualified in the safe operation of the device and its proper use when servicing motor vehicles
and their components. Examples of hazards are dropping, tipping or slipping of loads caused primarily by improperly securing loads,
overloading, off-centered loads, use on other than hard level surfaces, and using equipment for a purpose for which it was not intended.
mEtHoDS to aVoiD HaZarDoUS SitUationS
• The unlifted wheels of the vehicle should be chocked.
• Load should be centrally located on the head cap.
• No person should remain in a vehicle that is being lifted.
• Vehicle manufacturer owners manual should be consulted prior to lifting of vehicle.
• The hydraulic jack should be used for lifting and lowering only.
• Use only high quality hydraulic oil.
• Inspect the jack before each use. Do not use jack if damaged, altered, modified, in poor condition, leaking hydraulic fluid, or unstable
due to loose or missing components. Make corrections before using.
• Lift only on areas of the vehicle as specified by the vehicle manufacturer.
• Wear eye protection that meets ANSI Z87.1 and OSHA standards.
• Do not use jack beyond its rated capacity.
• This is a lifting device only. Immediately after lifting, support the vehicle with jack stands capable of sustaining the load before working
on the vehicle.
• Use only on a hard level surface free from obstructions so the jack is free to reposition itself during lifting and lowering operations.
• Center load on saddle. Be sure setup is stable before working on vehicle.
• Do not move or dolly the vehicle while on the jack.
• Do not use saddle adapters or saddle extenders between the stock lifting saddle and the load.
• Do not use any adapters unless approved or supplied by Arcan.
• Always lower the jack slowly and carefully.
• Failure to heed these warnings may result in fatal personal injury and/or property damage.
ConSEQUEnCES of not aVoiDing HaZarDoUS SitUationS
Failure to read this manual completely and thoroughly, failure to understand its OPERATING INSTRUCTIONS, SAFETY WARNINGS,
MAINTENANCE INSTRUCTIONS and comply with them, and failure to comply with the METHODS TO AVOID HAZARDOUS SITUATIONS
could cause accidents resulting in serious or fatal personal injury and/or property damage.
WARNING: Indicates a hazardous situation
which, if not avoided, could result in death
or serious injury.
WARNING
WARNING
WARNING
WARNING
ARCAN is a registered trademark of Powerstation LLC. All rights reserved.
