2
SAFTY Guidelines:
Take the appropriate steps to ensure that children have no access to the appliance.
Before using the appliance for the first time, an electrician must check that the necessary
electrical protection measures have been taken.
No one is in the liquid that will be pumped while the pump is in operation.
The pump may be operated in swimming pools, garden ponds, bog gardens, fountains and the like
only with a leakage-current circuit-breaker (maximum leakage current 30 mA as per VDE
Regulation Part 702). Please ask your electrician.
Inspect the appliance before each use. Do not use the appliance if the safety devices are damaged
or worn. Never deactivate the safety devices.
You are responsible for safety in the work area.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
Never lift, transport or secure the pump by its power cable.
Make sure the appliance is plugged into a socket in a place where there is no risk of flooding and
which is protected against moisture.
Always remove the plug from the socket before doing any work on the pump.
Avoid exposing the pump to a direct jet of water.
The operator is responsible for any local safety and installation regulations. (Ask your electrician
for advice.)
Rule out any indirect damage caused by the flooding of rooms following the failure of the pump
by adopting the appropriate measures (e.g. the installation of an alarm system, a reserve pump or
the like).
If the pump fails, any repair work necessary must be performed only by an electrician.
Use only original spare parts.
Never let the pump run dry and never operate it with fully closed intake power. The
manufacturer's warranty shall lapse if the pump is damaged due to it being allowed to run dry.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
When the pump intended to be connected to the water mains, additional backflow prevention
device shall be set to prevent backsiphonage of non-potable water into the water mains.
Commissioning
After installing the pump as indicated in these instructions, it is ready to work.
