Trolex TX2124, Руководство пользователя

Страница: 17 / 24

TX2124 User Manual
P5629.1600 Rev A 17
7 .1 LED Indication
• The Following table shows the status of the LED’s on the front of the TX2124
Module.
Port OFF FLASH ON
PWR (green) Power Fail N/A Power OK
WDG (red/green) Fault Green - Healthy (10Hz) Fault
WLAN (red/blue) Idle
Red (config mode) Blue
(data)
Red (fault) Blue
(connected) Purple
(connecting)
TX (green) Idle Transmitting Serial Data N/A
RX (red) Idle Receiving Serial Data
Fault – RX data polarity is
inverted
STAT (red/green) N/A
Green – Identify module
mode
Red (fault) Green
(healthy)
RJ45 ACT (yellow)
Ethernet link
disconnected
Ethernet link activity Ethernet link connected
RJ45 100 (green) 10Mbps N/A 100Mbps
7.2 Factory Reset
To reset the TX2124 to factory defaults, follow this sequence:
• Power on the unit and in less than 3 second press the reset switch – the green
status LED will go red and the green watchdog (heartbeat) LED will still keep
flashing (100Hz). This has factory default the unit. Cycle the power to reboot to get
rid of the red status LED back to green. The LAN IP will now be 192.168.0.200 and
other settings reset to factory.
• If the green watchdog (heartbeat) LED turns red and flashes very fast then the
button was pressed too quick after power-up and it is now in bootloader mode
instead. Cycle the power and try again.
• If the green status LED does not go red then the button was pushed too late
(> 3second) after power up. Cycle the power and try again.
www.trolex.com