Trojan MARATHON 230, Руководство пользователя

Страница: 26 / 28

26
TROUBLESHOOTING
NOTE:
Do not touch any internal electric wires without consulting the manufacturer.
TREADMILL WILL NOT START:
Make sure the power cord is plugged into a surge protector, the surge protector is plugged into a properly
grounded outlet and the surge protector is turned on (refer to the Power Requirements section in this
manual).
•
Check the circuit breaker reset switch located on the front of the Trojan Marathon 230 Treadmill. Turn
the Trojan Marathon 230 Treadmill off, wait 5 minutes then turn it back on and press the rest switch.
• Check the house electrical breaker box and the circuit breaker it is located in. If it has tripped, reset or
have an electrician replace the breaker in your home.
• Have an electrician check for inadequate voltage at the outlet.
TREADMILL LOSES POWER DURING USE:
• Have an electrician check for inadequate voltage at the outlet.
• Check the house electrical breaker box and the circuit breaker for the room the Trojan Marathon 230
Treadmill is located in. If it has tripped, reset or have an electrician replace the breaker in your home.
TREADMILL WALKING BELT SLOWS DURING USE:
• Check to make sure the Trojan Marathon 230 Treadmill is securely plugged into a UL-listed surge
protector, rated at 15 amps, with a 14-gauge cord of 5 feet or less and the surge protector is securely
plugged into the outlet.
TROJAN MARATHON 230 TREADMILL WALKING BELT SLIPS OR IS NOT CENTERED ON
REAR ROLLER:
Refer to Belt Adjustment section of this manual.
PROBLEM SOLUTION
There is no display on the
Console. 1. Remove the Console and verify the wire that comes from the
Console is properly connected to the wire that comes from the
Main Frame.
2. Check if the batteries are correctly positioned and that the
battery springs are in proper contact with batteries.
3. The batteries in the Console may be dead. Change to new bat-
teries.
Squeaking noise when in use. There may be a loose bolt, please inspect the bolts and tighten if
necessary.