EN
Note:
•
The fixing holes are pre-formed and
do not require drilling.
1. Seat
2. Fixing holes
4. Secure the reed-switch magnet from the
fitting kit to the fixing holes with the two
screws supplied.
Note:
•
Ensure the magnet is fitted in the
orientation shown below.
1. Seat
2. Reed-switch magnet
5. Position the reed-switch between the two
moulded lines on the right-hand side of
the battery box area. The top of the
reed-switch should be level with the top of
the frame.
1. Frame
2. Moulded lines
3. Reed-switch
Note:
•
Only drill through the plastic
moulding. Do not drill into any part
of the motorcycle frame.
6. Mark the position of the reed-switch fixing
holes, remove the reed-switch and drill a
hole in each marked position using a
2 mm diameter drill.
Note:
•
Read the warning notices printed on
the cleaning wipe packet in the
fitting kit.
•
The surface to which the
reed-switch is affixed must be clean
and dry to ensure that the adhesive
has a sound base to adhere to. Use
the cleaning wipe supplied for this
purpose.
2
1
cdsb
2
1
cdsc
1
3
2
cdsd
Publication part number A9900449, Issue 2, ADC 9148
© Triumph Designs Ltd 2009.