Triumph Adler LP 4014, Инструкция по эксплуатации

Страница: 138 / 182

Special Paper
5-8
5.3.2 Adhesive-Backed Labels
The basic rule for printing on adhesive labels is that the adhesive must
never come into contact with any part of the printer. Adhesive paper
sticking to the drum or rollers will damage the printer.
Label paper must be manually fed.
Label paper has a structure comprising three layers, as shown in
Table 5.1
Table 5.1 Table 5.1
Table 5.1
on page
5-2
5-2 5-2
5-2
. The top sheet is printed on. The adhesive layer consists of
pressure-sensitive adhesives. The carrier sheet (also called the linear or
backing sheet) holds the labels until use. Due to the complexity of its
composition, adhesive-backed label paper is particularly likely to give
trouble in printing.
Figure 5.1 Adhesive-backed label
Adhesive label paper must be entirely covered by its top sheet, with no
spaces between the individual labels. Labels with spaces in between are
apt to peel off, causing serious paper jam problems.
Some label paper is manufactured with an extra margin of top sheet
around the edge. Do not remove the extra top sheet from the carrier sheet
until after printing is finished.
Figure 5.2 Label arrangement
Top sheet (white bond paper)
Adhesive
Carrier sheet
Top sheet
Unacceptable Acceptable
Carrier sheet