Triumph Adler DCC 2725, Инструкция по эксплуатации

Страница: 68 / 468

Preparation before Use
2-30 OPERATION GUIDE
Originals Supported by the Document Processor
The document processor supports the following types of originals.
Originals Not Supported by the Document Processor
Do not use the document processor for the following types of originals.
• Soft originals such as vinyl sheets
• Transparencies such as OHP film
• Carbon paper
• Originals with very slippery surfaces
• Originals with adhesive tape or glue
• Wet originals
• Originals with correction fluid which is not dried
• Irregularly shaped (non-rectangular) originals
• Originals with cut-out sections
• Crumpled paper
• Originals with folds (Straighten the folds before loading. Failure to do so may cause the originals to jam).
• Originals bound with clips or staples (Remove the clips or staples and straighten curls, wrinkles or creases
before loading. Failure to do so may cause the originals to jam).
How to Load Originals
IMPORTANT: Before loading originals, be sure that there are no originals left on the original eject table.
Originals left on the original eject table may cause the new originals to jam.
1
Adjust the original width guides to fit the originals.
Weight 45 to 160 g/m
2
(duplex : 50 to 120 g/m
2
)
Size Maximum A3 to Minimum A5
Maximum Ledger to Minimum Statement-R
Capacity Plain paper (80 g/m
2
), Colored paper, Recycled paper:
100 sheets (Mixed sized originals: 30 sheets)
Thick paper (120 g/m
2
): 66 sheets
Thick paper (160 g/m
2
): 50 sheets
Art paper: 1 sheet
High quality paper (110 g/m
2
): 72 sheets