Triton T90xr, Инструкция по установке и эксплуатации

Страница: 16 / 29

T90xr pumped electric shower
Note: Make sure the Start/Stop button is
not depressed in the cover which indicates
‘
start
’. The button should be flush with the
cover, otherwise water will flow as soon as the
electricity is switched on.
Attached to the Stop/Start switch inside the
cover is a two wire lead. The socket on the end
of this lead must be connected to the plug that
is situated at the bottom of the right-hand side
of the backplate unit
(fig.) .
Note: The plug and socket can only fit one way.
Take care to ensure the flexible drip shield
around the solenoid is positioned correctly
(fig.)
.
Replace the cover squarely to the backplate and
guide into position so that the controls locate
correctly into the spindles while at the same
time, making sure the wires are not trapped.
Should any difficulty arise, recheck the points
above.
Secure the cover temporarily in position with
two retaining screws. DO nOT OVERTIGHTEn.
Switch on the mains electric supply to the
shower at the isolating switch.
Press the Start/Stop button
(fig.0) . The power
indicator will light and the pump starts to
operate.
It will take about thirty seconds for a smooth
flow of water to be obtained while air and any
debris is being flushed from the shower.
When a smooth flow of water is obtained, rotate
the temperature control from ‘1’ to ‘10’ several
times
(fig.)
to release any trapped air within
the unit.
Once flushing out has been completed, stop the
water flow by pressing the Start/Stop button.
SWITCH OFF THE ELECTRICITy SuPPLy TO THE
SHOWER AT THE ISOLATInG SWITCH.
unscrew the cover retaining screws again and lift
the cover from the backplate.
Remove the locking screw from the power
selector spindle
(fig.) and store for future
use. Make sure the selector spindle is left in the
same attitude.
Fig.0
Fig.
Position drip
shield as shown
Fig.