Triton T70Z, Инструкция по установке и эксплуатации

Страница: 18 / 28

T70Z electric shower
18
N-002-A
Note: In normal use, it is in order to leave the
water supply permanently on to the shower
unit, but as with most electrical appliances,
the unit must be switched off at the
isolating switch when not in use.
Power selector
Cold
Economy
High
Temperature
control
INCREASE
Flow = Decreased
Temperature
Fig.19
OPERATING THE SHOWER
Make sure the commissioning procedure
has been carried out.
To start the shower
Turn the power selector to either Cold, Economy
or High and the water will flow.
To stop the shower
Turn the power selector to the OFF position.
Note: If restarting immediately after stopping,
be aware that a slug of hot water will be expelled
for the first few seconds.
To use the power selector
The power selector has three ON positions –
COLD, ECONOMY and HIGH
(fig.19) .
The BLUE symbol is for cold water only.
Adjusting the temperature control at this setting
will only change the force of the water from the
shower head, it will not alter the water
temperature.
The RED symbol is an economy setting for
using less energy when the ambient mains water
temperature is high during warmer months.
Temperature adjustment at this setting is via the
temperature control
Note: If the stated flow rate required for the unit
cannot be met due to low water pressure, it will
be necessary to operate the unit on this setting
during the warmer months because of flow rate
limitations entering the unit.
The RED symbol is a high power setting which
allows the highest flow achievable for your
preferred temperature. This setting should
normally be regarded as optimum shower
performance throughout the year. Temperature
adjustment is via the temperature control.
To adjust the shower temperature
The water temperature is altered by increasing or
decreasing the flow rate of the water through the
shower via the temperature control
(fig.19) .
After obtaining your showering temperature, the
knob can be left as the normal setting and should
only need altering to compensate for seasonal
changes in ambient water temperature.
DECREASE
Flow = Increased
Temperature
Off