Triton T70si, Инструкция по установке и эксплуатации

Страница: 15 / 24

T 7 0 s i
Replace the upper bracket onto the rail and
secure the bracket to the wall with the screws
supplied
(fig.23) .
F Place a trim cover onto each bracket ensuring
the large protrusion at the narrow end of the trim
cover, engages into the slot between the rail and
bracket
(fig.24) before pushing and clicking the
other end into place (fig.25) .
FITTING THE HOSE AND SPRAYHEAD
Feed the flexible hose through the hose retainer
(fig.26) in order that it acts as a retaining ring
(Water Regulations).
Screw the flexible hose to the shower outlet and
sprayhead
(fig.27) ensuring the supplied washers
are in place at both ends of the flexible hose.
Place the sprayhead into the holder (fig.28) and
check that it fits correctly. NOTE: The holder is
slightly tapered and the sprayhead and hose will
only fit from one direction.
Important: It is the conical end of the hose which
grips into the holder. The sprayhead will not fit in
the holder without the hose attached.
However at this stage, disconnect the sprayhead
and lay aside until the shower unit has been
commissioned.
TIGHTENING THE SPRAYHEAD HOLDER
In the unlikely event of the sprayhead dropping
down in use because the holder is loose, this can
be remedied by re-tightening the screw inside the
holder unit. To gain access to this screw, one of
the wall mounting brackets must be removed –
the top one is preferable as the rail can be left in
position on the lower bracket.
First remove the sprayhead and hose from the
holder. Insert a small screw driver into the slot on
the trim cover
(fig.29) , and carefully prise off the
cover.
Unscrew the fixing screws holding the bracket
and remove it from the wall and rail.
Holding the rail, unlock the lever and slide off the
lever and holder assembly. Remove the lever and
saddle from the slider/holder assembly. The screw
inside the slider/holder is now accessible.
With an appropriate screw driver, tighten the
screw
(fig.30) . Re-assemble in the reverse order.
Washers
Shower
Sprayhead
Fig.26
Sprayhead
Holder
Fig.25
Fig.27 Fig.28
Screw
Slider/holder
assembly
Fig.29
Fig.30
13