18
Installation
- FITTING THE COVER
8
check list
SECTION
SECTION
FITTING THE COVER
IMPORTANT:
Before finally fitting the cover, the
following steps must be taken:
a.
Check the plumbing connections are
watertight.
b.
Check the terminal block screws are fully
tightened.
c.
Make sure the pipe and cable entering
the unit do not prevent the cover locating
correctly to the backplate.
d.
Check the power selector is in the COLD
position and the temperature control
points to number ‘10’.
• Offer the cover to the unit.
• Plug the neon located on the backplate into
the bracket inside the cover
(fig.13)
. The
neon clips into the housing on the back of the
START/STOP button.
• Carefully guide the cover onto the backplate
making sure the wires are not trapped.
NOTE:
DO NOT
remove the cable tie in this unit.
Figs 14, 15, 16
and
17
on page 20 show the
correct control knob position when replacing the
cover.
• Check to ensure that the wiring is not
trapped and replace the cover squarely to
the backplate and guide into position so that
the knobs locate correctly into the splined
spindles.
•
Should any difficulty arise, recheck the
points above.
• While applying slight pressure to the cover,
secure in position with the retaining screws.
•
Fit the Riser Rail and Kit
(see kit
instructions).
Fig.13
WARNING
COVER RETAINING SCREWS
ONLY
the
SUPPLIED SCREWS
should be
used. The use of non supplied screws
WILL
invalidate product specifications & warranty.
