6
SDD
to
NMD-50 C
oNverSioN
P
roCeDureS
u
PgraDe
K
it
a
SSeMbly
P
roCeDureS
/ S
liDeS
2.
Right Side Slide Rail - Remove the dispenser slide bracket from the slide assembly. Pull the slide assembly open about
8 inches, enough to expose the rear most mounting holes. There are four (4) mounting holes in the adapter bracket
just installed. Attach the slide assembly to the adapter bracket starting in the REAR. The SECOND hole from the rear
of the slide assembly, mates with the REAR most hole in the adapter. Once that screw (8-32x3/8) is inserted, (do not
tighten) you can maneuver the slide to gain access to the three (3) remaining mounting points. Once all four (four)
screws are started, tighten snuggly. When installed, the slide rail (pushed in) should be even with the door flange.
Move the power, comm and ground cables, and close the door to ensure there is no interference. Open the door and
rehang the cables. DO NOT be tempted to leave any hardware uninstalled. The dispenser is heavy and all hardware is
essential to its security.
Ferrite
1.
Right Side Slide Assembly - Mount the slide adapter bracket to the right side of the cabinet with the two (2) bolts
provided (1/4-20x1/2). The mounting points are at the ends of the bracket, on the TOP.
3.
Left Side Slide Rail - Remove the dispenser slide bracket from the slide assembly. Mount the other slide rail to the left
cabinet bracket using THREE (3) 8-32x3/8 phillip head screws. There are only three (3) mounting locations that align.
Starting in the REAR, mate the REAR most slide assembly hole with the REAR most bracket hole. Once that screw is
inserted, (do not tighten) you can maneuver the slide to gain access to the TWO (2) remaining mounting points, toward
the front of the slide assembly. Once all three (3) screws are started, tighten snuggly. When installed, the slide rail
(pushed in) should be even with the door flange. DO NOT be tempted to leave any hardware uninstalled. The dispenser
is heavy and all hardware is essential to its security.
Note:
When installing the slide rail, ensure any exposed cables in
the back of the cabinet are “tucked” behind the cabinet bracket.
Slide rails will be offset when extended, right will
be longer.
Adapter bracket.
Cabinet bracket.
Slide rail extended.
Assembly mounted to cabinet.
Slide rail installed. (representative)
Cabinet bracket. (representative)
Rails extended (offset).
Right will be longer
Seven screws (8-32x3/8)
to attach slides. Four right
and three left.
