© Triton Electronics Ltd 2022
Doc. AMV35003_1.doc v1.04
PAGE 6 OF 52
1.1.5
Gas Flow Sensor
The gas flow sensor is plumbed into the gas flow line. The
direction of flow is marked on the sensor.
1.1.6
Travel Speed Sensor
The travel sensor is a surface contact sensor for monitoring table or
welding torch speeds. The mounting of the sensor is dependent on the
application, it can be by surface wheel or through the gear train. Output
pulses are calibrated by the AMV to give results in speed (units can be
specified at calibration) or RPM as the application dictates.
1.1.7
Voltage breakout box (P316)
The voltage breakout board provides an easy way to integrate additional sensors to the AMV weld
monitors. The P316 is intended for a device that outputs voltage that can feed into the +/- 3V input
stage on the AMV.
In addition, it can also power device from the internal 12V AMV power bus. Max drain 20mA.
Connections are made by screw terminal.
1.1.8
4-20mA Breakout box (P362)
The voltage breakout board provides an easy way to integrate additional sensors to the AMV weld
monitors. The P362 is intended for a device that outputs a 4-20mA signal that can feed into the +/-
3V input stage on the AMV.
In addition, it can also power device from the internal 12V AMV power bus. Max drain 20mA.
Connections are made by screw terminal.
