Triton Blue WALLY SC 20, Руководство пользователя

Страница: 8 / 19

- - XM572-V1.0-NR
６
Projector DMX start address selection
All fixtures should be given a DMX starting address when using a DMX signal, so that the correct fixture
responds to the correct control signals. This digital starting address is the channel number from which the
fixture starts to “listen” to the digital control information sent out from the DMX controller. The allocation of
this starting address is achieved by setting the correct number on the display located on the base of the device.
You can set the same starting address for all fixtures or a group of fixtures, or make different address for each
fixture individually.
If you set the same address, all the units will start to “listen” to the same control signal from the same channel
number. In other words, changing the settings of one channel will affect all the fixtures simultaneously.
If you set a different address, each unit will start to “listen” to the channel number you have set, based on the
quantity of control channels of the unit. That means changing the settings of one channel will affect only the
selected fixture.
In the case of the scanner, which is 9 channel fixture, you should set the starting address of the first unit to 1,
the second unit to 10 (9 + 1), the third to 19 (10 + 9), and so on.
Note:
The modes of DMX 512 data are shown via the display:
DMX OK NO DMX
1. After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the display will show
"A.001"
with the actually set address. If there is no data received at the
DMX-input, the display will flash
"A001"
with the actually set address.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap in
the input connector.
It’s necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
Control Board
There are four keys on the control panel , which could be used to set the address, turn ON/OFF, operating the
program and reset.
[Mode/Esc]
press this key to enter into edit mode. Press this key under the edit mode if you want to return to
previous menu. it will exit from edit mode 60 seconds after the last keypress