For safety reasons, please be aware that all modifications on the device are forbidden.
If this device will be operated in any way different to the one described in this manual, the product
may suffer damages and the guarantee becomes void. Furthermore, any other operation may lead to
short-circuit, burns, electric shock, lamp explosion, crash, etc.
INSTALLATION INSTRUCTIONS
a)
Installing or replacing the lamp
h a higher wattage. They generate higher temperatures than which the device was designed for.
For the installation, you need one
MSR 1200 SA GY 22 lamp ;
Procedure :
1) Unscrew the 4 screws marked Y, X, W and Z on the back of the housing, holding the plate where
the lamp is underneath.
2) Gently pull the socket holder of the lamp housing in the middle.
3) Carefully insert the lamp into the socket. Please remember there is only one way to insert the lamp.
Gently slide the lamp and its lamp holder back into place and fasten the 4 screws.
4) On the access plate there are 3 small screws marked A, B and C. which are used to adjust the lamp
holder in the lamp housing. You can adjust the 3 screws to fine-turn the position of the lamp to get
the maximum light output as shown below.
A
B
C
A
B
C
Please remember the lamp is not a hot-restrike type, you must wait for approximately 10
minutes after having turned off the lamp before you can turn it back on again.
CAUTION
Do not operate this device with open cover
b)
Mounting the device
-
４
- GS-SMS-Y1200-V1.0-02NR