4
4. Setup
Caution! Read All Instructions and Warnings Before Installation!
Warning: Charging stations can be extremely heavy. Do not attempt to unpack or mount the charging station without
assistance. Follow the unpacking instructions document that shipped with this product before proceeding with setup. Use
extreme caution when handling the charging station and be sure to follow all handling and installation instructions. Do not
attempt to install equipment without first stabilizing the charging station.
4.1 Power Requirements
4.2 Installing the Handle Bracket and Power Cord Manager
4.3 Adjusting Storage Shelf Dividers
The charging station can be plugged into an AC outlet with a dedicated circuit. An AC outlet with a 20-amp (NEMA 5-20R) AC circuit is recommended
for powering the charging station. The AC outlet used to power the charging station should not be shared. The total wattage of the charging station and
all connected components should not exceed 1440 watts.
To install the handle bracket, use the included hex key tool to attach four (4) hex screws to the charging station cabinet
A
. To install the cord
manager, use the same hex key tool to secure the eight hex screws that attach the cord manager brackets (four per bracket) to the charging station
cabinet
B
.
Your charging station comes with two storage shelves with adjustable dividers that can
each accommodate up to 16 personal electronic devices per shelf.
Remove any personal electronic devices stored on the shelf tray. Then remove the
blanking panel. To remove the shelf tray from the cabinet, push the shelf tray forward
to disengage from the mounting hook, then pull the tray up and out. Once the shelf is
removed, remove or rearrange the dividers by pushing in the two tabs securing the
divider to the rear end
A
, then push the divider forward to disengage from the shelf
tray
B
. Repeat as necessary for additional shelf dividers.
A
B
B
A
