8A
Mounting
WARNING! Mount your Inverter/Charger BEFORE DC battery and AC power
connection. Failure to follow these instructions may lead to personal injury
and/or damage to the Inverter/Charger and connected systems.
Tripp Lite manufactures a variety of different Inverter/Chargers with a variety of different mounting options for use in vehicular or non-vehicular
applications. Tripp Lite recommends permanent mounting of your Inverter/Charger in any of the configurations illustrated below. User must
supply mounting hardware and is responsible for determining if the hardware and mounting surface are suitable to support the weight of the
Inverter/Charger. Contact Tripp Lite if you require further assistance in mounting your Inverter/Charger.
Vehicular and Non-Vehicular Horizontal Mount
(750 and 1250 models only)
Using the measurements from the diagram, install two user-sup-
plied ¼" (6 mm) fasteners into a rigid horizontal surface, leaving
the heads slightly raised.
Slide the Inverter/Charger back over
the fasteners to engage the mounting slots molded on the bottom of
the Inverter/Charger cabinet.
Install and tighten two user-sup-
plied ¼" (6 mm) fasteners into the mounting feet molded on the
front of the Inverter/Charger cabinet.
Vehicular and Non-Vehicular Horizontal Mount
and Non-Vehicular Vertical Mount
(2012, 2424 and 3636 models only)
Using the measurements from the diagram, install two user-sup-
plied ¼" (6 mm) fasteners into a rigid surface, leaving the heads
slightly raised.
Slide the Inverter/Charger forward over the
fasteners to engage the mounting feet molded on the front of the
Inverter/Charger cabinet. Install and tighten two user-supplied
¼" (6 mm) fasteners into the mounting feet molded on the rear
of the Inverter/Charger cabinet. The rear feet extend beyond the
unit’s cabinet to provide for adequate ventilation space behind the
cooling fan(s); they should not be removed.
A
B
C
A
B
C
A
C
B
M
A
C
B
M
Vehicular and Non-Vehicular
(2012, 2424 and 3636 models only)
• Horizontal Mount • Vertical Mount • Inverted Mount
Tripp Lite’s Lateral Mounting Bracket (available as an option-
al accessory from Tripp Lite*) provides a rigid surface for lat-
eral mounting in vehicular or non-vehicular applications.
Consult the instructions packed with the Lateral Mounting
Bracket for complete mounting information. Note: your
Inverter/Charger is not designed nor covered under warranty
for vertical or inverted mounting in a vehicular application.
Such mounting may be possible, however, when your
Inverter/Charger is properly secured to a Lateral Mounting
Bracket. As with any mounting, user is responsible for deter-
mining if the Inverter/Charger can be mounted safely relative
to their application. Since securing an Inverter/Charger to a
Lateral Mounting Bracket which is not factory pre-installed
will require some modifications to the Inverter/Charger cabi-
net, please consult the Lateral Mounting Bracket owner’s man-
ual prior to purchasing.
* Contact Tripp Lite for ordering information.
Note: APS model cabinets may have different front panel features, but all have identical mounting. Vertical Mount for select
models only.
A
C
B
Lateral Mounting Bracket
M
M
M
M
M
M
11.4 cm
17.1 cm
20 cm
14.16 cm
38.12 cm
M
M
M
M
M
M
M
M
38.12 cm
14.16 cm
200608120 93-260
8
230V APS OM.qxd 10/16/2006 10:46 AM Page 8
