7
7
、
Alarm Installation
The DVR has an internal switch for sounding alarm. The switch is normally open, but
when the sensor is triggered, the alarm is activated as well.
Connects the alarm signal lines to alarm switch terminal on rear panel and connect
the alarm power lines to power source.
8
、
Network Connection
Connect the LAN port on rear panel with router for remote monitoring, recording and
controlling via internet or local area network.
More network connecting information; please refer the Player and Remote Monitoring
chart for Net Viewer setting and remote controlling through IE Browser and DDNS
Setup.
Getting Start Operation
1
、
Start Up the DVR System
After the DVR unit and all the peripherals are properly installed, the DVR is ready to
record and play. Then apply power and switch on.
After the unit is powered on, the DVR will check HDD for several seconds, and then
DVR will enter into real-time display mode.
When installing a new HDD, please press “
►
PLAY
※
” to format HDD
If there is no HDD connected, it will show message as bellow
