3
2.14
Do not exceed the maximum voltage or current limitations of the meter
(see product specifications). Doing so may damage the meter and/or
injure the user.
2.15
Do not apply voltage or current to the input of the meter when it is set to any
of the Ohms
Ω
ranges. Doing so may damage the meter and/or injure
the user.
2.16
Do not apply voltage or current to the input of the meter when it is set to the
Diode Test
or Continuity Beeper
modes. Doing so may damage
the meter and/or injure the user.
2.17
Do not attempt to measure a voltage source with the test leads plugged into
the meter’s mA or 10A jacks. Doing so may damage the meter and/or
injure the user.
2.18
Do not rotate the Function switch with the test leads connected to the
circuitry to be tested. Doing so may damage the meter or the circuitry,
and/or injure the user.
2.19
Replace fuses only with exact or equivalent fuses. Do not “bridge” fuses out
of circuit. Failure to observe this precaution may result in damage to the
meter or injury to the user.
2.20
Do not apply voltages to the input of the meter which are elevated above the
earth ground potential by more than 600V AC/DC. Doing so may damage
the meter and/or injure the user.
2.21
Do not continue to use meter when the “low battery” symbol
+
_
is
displayed. The displayed reading may be in error and lead the user to
believe that no hazard exists, when in fact, dangerous voltages or currents
may be present. Failure to observe this precaution may result in damage to
the meter or injury to the user.
2.22
Use caution when working with voltages above 25 volts AC or 35 volts DC.
Such voltages may cause a life threatening electrical shock.
2.23
This meter is not for use by children. Failure to observe this precaution may
result in damage to the meter or injury to the user.
2.24
Do not use this meter to make measurements in adverse environments such
as rain, snow, fog, or locations with steam, explosive gases or dusts.
Doing so may damage the meter and/or injure the user.
2.25
Do not use meter in condensing atmospheres. That is, do not use meter in
conditions where ambient temperature and humidity could cause condensa-
tion of water inside of meter. Doing so may cause injury to the user.
Downloaded from
Arrow.com.
Downloaded from
Arrow.com.
Downloaded from
Arrow.com.
Downloaded from
Arrow.com.
