14
Triple Solar assembly instruction PVT heat pump panels March 2020
•
The heat pump panel is now first attached to the rails, see 7.2 and 7.3. The TS clamping profile is only
later on pushed into the panel profile, see 7.4. Until then, the TS clamping profile lies loose at some
distance from the panel profile.
Mounting of the panels
1) Insert a long M8 bolt into a hole in the end profile on each side of the heat pump panel to prevent
it from slipping. See figure 7.2-a.
Figure 7.2-a panel with M8 bolt to prevent slipping.
2) Lay down the outer heat pump panel and align it (take into account the installation of any
accessories such as a cover plate for the piping, this requires 115 mm mounting rail, see chapter
9.
3) Secure the outside of the panel with the TS end clamp (#310100) and socket head screw M8x40
(#331150), see figure 7.2-b
Figure 7.1-c the TS clamping profile lies loose, until the panels are permanently fixed.
