TTrig
//
Quick Guide
5
D04-05Aen201908 Quick Guide TTrig
TriOS Mess- und Datentechnik GmbH · Bürgermeister-Brötje-Str. 25 · D-26180 Rastede · Germany
Phone: +49 (0) 4402 69670 - 0 · Fax: +49 (0) 4402 69670 - 20 · [email protected] · www.trios.de
In comment line 3 each measurement is assigned a consecutive number.
Failed measurements, e.g. due to service or power fail, are internally incremented in TTrig.
In this case, the number of the subsequent measurement is not consecutive.
The numbering of the measurements enables the user to subsequently correct fluctuations of the sensor-internal RTC (Real Time
Clock).
Comment line 4 contains additional event information suchas timeout, power fail, etc.
In the case of omitted measurements, their number can be read at "EVENT-SKIPPED #".
TTrig Reset
Reset resets the TTrig to its initial position.
Automatic measurement is stopped and the numbering of the measurements is reset to 1.
1. INTERVAL and 2. DELAY can now be reconfigured. By pressing the start button the TTrig takes over the settings of the rotary
encoders into the new automatic measurement.
All stored data of the sensor is retained!
If the web interface is also not available, please contact us at [email protected].
Troubleshooting
Power fail
:
A power fail occurs when the power supply is no longer sufficient for the next measurement. The red POWER FAIL LED flashes and
no more measurement is triggered in the following 12 hours. Every 12 hours, the TTrig will automatically check the performance
of the power supply.
The start button can be used to trigger a manual check of the voltage source.
The TTrig resumes automatic measurement when sufficient power is available.
Sensor not found:
Check the connector and the cable of the sensor. Carry out a reset and press the start button again after one minute.
Sensor detected
Measurements are carried out fully automatically.
Sensor not detected
Connect to the G2 interface of the sensor and check the settings of the serial interface under the menu
"Peripherals".
