Triogen CH2-50-1, Инструкция по установке и эксплуатации

Страница: 19 / 24

17
OPERATION & MAINTENANCE
It should be noted that the noise emitted by the generator may fluctuate as the
output is varied but this will stabilise within a few minutes as the temperature of
the inner electrode increases or decreases in accordance with the amount of
power supplied to the ozone module.
The ozone system has been designed for either periodic or continuous running
with the minimum of maintenance and supervision but the following
checks should be carried out at a minimum of once per week.
Check that ozone generator and air dryer indicator lights are illuminated when
the system should be in operation.
Check the level of water in the water trap pot and top up as required to the
correct level of 25mm from the top of the pot.
Check that the correct airflow is being drawn through the ozone generator and
adjust if necessary.
Check that the injector booster pump is operating correctly.
On systems fitted with the optional degasser system, it is necessary to check the
activated carbon in the activated carbon filter pot which will degenerate
through usage. When the carbon level falls to approximately 25mm from
the top of the container the system must be topped up.
Note: It is the responsibility of the user to ensure that the correct level of
activated carbon is maintained. Spare activated carbon can be purchased
in 2kg packs from Triogen or your local distributor.
Maximum output of the generator is attained when the control knob is set to
position 10. The airflow through the generator should be maintained at the
recommended 10-12 litres/minute, irrespective of the setting used for the
variable output.