天合光能
TS4
连接器安装手册
Trina Solar TS4 Connector Installation Manual
15
与铆接口齐平。钳口选择参照
5.1.2
章节。
Place the metal terminal (pin or socket) in the hole of the riveting tool. The riveting hole is
facing out. The most outer edge of the metal terminal is flat with the riveting interface. Refer to
chapter 5.1.2 for jaw selection.
5.2.3
铆接插针插套
Crimping pin and socket
将剥好线的线芯插入金属端子铆接孔内，需确保所有芯线都在孔内。保证金属件和线缆
线的同轴度。最后按下铆接工具手柄，一直按到底，完成铆接。铜丝都要被包扎。
Insert stripped cable into the rivet hole of the metal terminal, and make sure all the individual
strands are in the hole. Ensure the coaxially of metal parts and cables. Finally, press the riveting
tool handle all the way and press it to the end to complete the riveting. All individual strands
should be crimped.
对于
O
型金属端子使用的铆接钳（
7A001036
）
，需根据不同规格线缆，先调节钳
口到相应的档位，调节旋钮高度使得金属端子的最外侧边缘与铆接口齐平。如下图。
For the crimping pliers (7A001036) used for O-type metal terminals, adjust the jaw to
the corresponding gear according to different specifications of cables, and adjust the height
of the knob so that the outermost edge of the metal terminal is flush with the riveting
interface. See Below.
旋钮
knob
