TriMark e-FOB, Руководство по установке

Страница: 16 / 24

The alarm is activated with a security trigger input or if the ignition is
started. The horn, siren, parking lights and head lights flash for 30
seconds. The starter kill is activated for 30 minutes. Press the Lock or
Unlock buttons to deactivate the alarm.
There is a 5 second delay before the system will recognize a security
input. If a security input (door ajar switch, motion sensor, glass break
sensor, etc.) is triggered while the alarm is armed, the security input
must be turned off and then on before the alarm is activated. The horn
and siren chirp 3 times if a security input is active when the alarm is
armed.
Lock/Unlock Confirmation Control
The siren and horn confirmation is controlled by pressing lock, unlock,
and auxiliary (*) buttons at the same time. A single chirp is heard when
confirmation is muted. A double chirp occurs when turned on.
Cargo mode: entry lock, entry unlock, cargo unlock.
Training Wireless Switches
Up to 20 wireless switches can be trained to the RF controller. A
wireless switch can provide door ajar information, input from a shock
sensor, a motion sensor, a glass break sensor, etc.
1. Plug the LED into C6 and the programming button into C7 on
the receiver.
2. Turn ignition off and disarm alarm.
3. Press and release the programming button 5 times. The LED
will turn on green after 2 seconds.
4. Press the programming button X number of times to store the
wireless sensor in X position (1-25). The LED will briefly flash
red.
5. Remove the magnet from the wireless sensor to activate the
output. The horn will honk and the siren will sound.
6. Repeat steps 4 and 5 to train additional wireless sensors. If two
sensors are trained to the same position, only the second
sensor will be active.
•
As soon as the LED turns off, the system is fully functional.
•
The system exits learn mode after 10 seconds of inactivity.
•
To erase all wireless sensors, turn ignition on and press
the programming button 10 times. The horn and siren will
sound once to indicate that all sensors have been erased.
•
The memory for codes will not be erased if power is
removed.
13