TriMark 540-0200, Руководство пользователя

Страница: 7 / 12

Teaching Keypad New Authority / Access Codes
IMPORTANT: READ ALL INSTRUCTIONS FOR EACH OPTION AND
ALL NOTES BEFORE BEGINNING TO KNOW WHAT TO EXPECT
DURING THE PROGRAMMING PROCESS.
The
Authority Code
has only one purpose; it grants the owner the ability
to set new
Access Codes
. The
Authority Code
must be EXACTLY 5
digits long. There are two ways to set the A
uthority Code
with the
Tri
Mark
Full Feature System. Changing the
Authority Code
erases all
previous
Access Codes
and sets a new
Access Code
in memory bank
1 that is the same as the new
Authority Code
.
Important:
Authority
and
Access Codes
should be different for the
greatest security.
Program New Authority Code
Preparation:
1. Find the wiring harness coming out of the back of the keypad.
Sometimes there is an access panel to the back of the keypad
inside the vehicle. If not, you will need to remove the keypad
from the vehicle.
Programming:
1. With the keypad still powered (this may require that the door be
shut), short the yellow wire to ground for about 5 seconds, or until
the keypad begins to beep.
2. The keypad will beep for 3 seconds;
remove the short before the
keypad stops beeping.
The keypad is now in “Learn Mode.”
3. Enter a new 5-digit
Authority Code
(double chirps after each
button press). The keypad chirps 3 times after the 5
th
digit’s entry.
4. Re-enter the new
Authority Code
for confirmation. The keypad
will chirp FOUR times for successful confirmation. A long beep
indicates a failure to change the code.
5. Test the new code to confirm it.
The following area can be used to document the new
Authority Code
:
Authority Code
Digit 1 Digit 2 Digit 3 Digit 4 Digit 5
5