Trikdis T16 Series, Руководство по установке

Страница: 7 / 21

www.trikdis.com 7 May, 2019
RF transmitter T16
Terminal Description
-DC Power supply terminal (10-15 V DC negative terminal)
Rx/CLK Security control panel’s serial port terminal CLK
Tx/DATA Security control panel’s serial port terminal DATA
A 485 Terminal A of RS485 bus
B 485 Terminal B of RS485 bus
COM/RING Common (negative) terminal or RING terminal of cellular communicator
TIP TIP terminal of cellular communicator
IN1/R-1 1
st
input terminal, selectable types: NC, NO, EOL (2,2 kΩ). (factory setting NO) or
terminal for monitoring the landline
IN2/T-1 2 nd input terminal, selectable types: NC, NO, EOL (2,2 kΩ). (factory setting NO) or
terminal for monitoring the landline
IN3 3 rd input terminal, selectable types: NC, NO, EOL (2,2 kΩ). (factory setting NO)
IN4 4
th
input terminal, selectable types: NC, NO, EOL (2,2 kΩ). (factory setting NO)
COM Common (negative) terminal
IN5 5 th input terminal, selectable types: NC, NO, EOL (2,2 kΩ). (factory setting NO)
IN6 6 th input terminal, selectable types: NC, NO, EOL (2,2 kΩ). (factory setting NO)
OUT1 Output terminal, open collector type, current up to 1 A
1.5 LED indication of operation
Indicator Light status Description
NETWORK Green blinking The radio transmitter is sending data
DATA Green solid There are unsent event messages in the memory
buffer
Red solid Memory buffer overflow
Red blinking (1/1) Security control panel connection problem
Red blinking (1/10) RS-485 module connection problem
POWER Green blinking Power source voltage is present
Yellow blinking Low level power source voltage
Green and yellow blinking (configuration mode) USB cable is connected
1.6 Components necessary for installation
Before beginning installation, ensure that you have:
1. A USB cable, needed for configuration (Mini-B type);
2. At least 4-wire cable for connecting the transmitter to the security control panel;
3. The manual of the security control panel to which the transmitter will be connected to;
4. An antenna;